Inserting numeric values |
When you assign commands, which need to insert any numeric value, a dialog opens. The input value can be inserted using this dialog.
You should insert the number here and after then you must confirm the value by either pressing the button with a green tick or clicking outside the dialog.
If you decide not to insert a number, press the button with a red-cross mark. The dialog will be closed and the original state of the icon will be restored.
If you make a mistake and write some wrong number, you can use the button with a left arrow to delete the last number (or more numbers).
If you have inserted a value for the first time after assigning the command, a default value will differ according to the command you have used:
Wait
- No value is assigned and the command waits until any key is pressed.
Baltie's Speed
- 1 is assigned as a default value. In addition, this command has a special feature - the window doesn't allow you to insert more than one number. When you press the next one, the original value is replaced with the new one.
Counted Loop
- One iteration is assigned.
Wait
- No value is assigned and the command waits until any key is pressed.
Baltie's Speed
- 1 is assigned as a default value. In addition, this command has a special feature - the window doesn't allow you to insert more than one number. When you press the next one, the original value is replaced with the new one.
Counted Loop
- One iteration is assigned.
Did you find this information useful?
Documentation of SGP Baltie 4 C#
Send us comments on this topic by this form ©1978-2010 SGP Systems
Parent page | Previous page | Next page